UNIX pc fan 27CFM vs. 34CFM and 12VDC vs. 120VAC?

Lenny Tropiano lenny at icus.UUCP
Thu Jun 23 11:48:47 AEST 1988


About 4 months ago I replaced my *DEAD* UNIX pc fan with a Radio Shack
12VDC 27CFM (cubic feet/minute) 3.5" look-alike.  Back then I didn't have
any problems, but just recently I'm experiencing sporatic memory parity
errors.  Diagnostics show nothing, although I think I am attributing it
to the extreme heat and humidity my bedroom is experiencing.

A little about my configuration:
	67MB 3B1 with 3.0MB RAM (1 dual EIA w/1.0MB on the board)
	DOS-73 board
	two Radio Shack 3.5" 27CFM 12VDC fans

A little about my problem and a few questions:
  ...
  NMI (parity error) at 0x2FFAC8 (*hpte: 0xE17B) Wed Jun 22 15:00:07 1988
  NMI (parity error) at 0x84298 (*hpte: 0x412F) Wed Jun 22 17:52:22 1988
  NMI (parity error) at 0x84298 (*hpte: 0x412F) Wed Jun 22 17:52:28 1988
  NMI (parity error) at 0x84298 (*hpte: 0x412F) Wed Jun 22 17:53:02 1988
  NMI (parity error) at 0x82200 (*hpte: 0x4169) Wed Jun 22 19:05:11 1988

  Problem didn't exist in cool weather even with the EIA/RAM expanded memory.
  Problem didn't happen [as often] with EIA/RAM board out.
  Machine is running 24 hrs/day 7 days/wk.
  Programs die with "Memory fault - core dumped" (signal 8) when the
     NMI parity error occurs. (as suspected)
  All socketed memory is seated tight.

  Boards get very hot, does this effect memory?
  Addresses vary from low 0x80000 to high 0x2FFFFF (does the lower addresses
     correspond to physical location of memory or just where the program is
     at that time which can be on either the motherboard memory or expanded
     memory?
  Was the 3B1 original fan a more output (ie. 34CFM) and maybe it is not
     pulling enough cool air?
  How does the heat and humidity affect the operation?
  Will air conditioning alliviate this?
  What does "(*hpte: 0x4169), etc..." mean?
  Using the "s4test" expert mode can I run the memory parity test on
     a particular segement is a "SOAK" mode where I it will run over and
     over on that test?
  
  Sort of related question...

  Has anyone tried the 120VAC fan instead of the 12VDC fan and reduce
     the strain on the power supply?  Does the AC hum interfere with
     any operation?


	Thanks for any help,
	Lenny
-- 
US MAIL  : Lenny Tropiano, ICUS Software Systems      IIIII  CCC U   U  SSS
           PO Box 1                                     I   C    U   U S
           Islip Terrace, New York  11752               I   C    U   U  SS 
PHONE    : (516) 968-8576 [H] (516) 582-5525 [W]        I   C    U   U    S
TELEX    : 154232428 [ICUS]                           IIIII  CCC  UUU  SSS 
AT&T MAIL: ...attmail!icus!lenny  
UUCP     : ...{talcott, boulder, pacbell, sbcs, mtune, bc-cis}!icus!lenny 



More information about the Comp.sys.att mailing list