Configuring s Versativ Plotter using a Ikon Broad

[Robert C. Montjoy]

Hi.

I am trying to configure an Ikon broad(on a sun3/160C for use with a
Versatic Plotter.  I have just upgraded to sunOS 4.0.3 and would like to
get this plotter going again. I need to know how to configure this broad
into the kernal for device driver support. Any clues would be gladly
accepted.

Also, we  are getting in a fleet off spaecstaions all of which have the
built in parallel port. I am wondering if I can use this to drive the
plotter.


Thanks.
ROB Montjoy

E-MAIL		Rob.Montjoy at uc.edu
		uunet!uccba!ucece1!montjoy
		montjoy at ucece1.ece.uc.edu