3/80 SCSI cables
Jon Mandrell
amc-gw!jon at entropy.ms.washington.edu
Fri Sep 29 05:51:14 AEST 1989
>> +------------------------+------+ <= ribbon cable
>> | | |
>> | | header, connect to internal drive
>> | header, connect to board
>> Old-style Sun connector, connect to shoebox cable
>On a related issue: the docs I've seen say that mixing embedded and
>adaptec/emulex SCSI drives on the same 3/80 is "not supported". Any ideas
>on what this really means? If you try, do you get even stranger unit
>numbers than before?
I have not had a problem at all. The ID's came up the same as on the
old 3/50 and 3/60 that I used before. The drives are as follows:
drive sd0 - SCSI ID 0
drive sd2 - SCSI ID 1
drive sd4 - SCSI ID 2
drive sd6 - SCSI ID 3
drive st0 - SCSI ID 4
Jon Mandrell, Applied Microsystems Corp., (jon at amc.com or ..!uunet!amc-gw!jon)
More information about the Comp.sys.sun
mailing list