Sparcstation 2 speed

[Bruce Allen]

In article <2171 at brchh104.bnr.ca> ballen at csd4.csd.uwm.edu (Bruce Allen) writes:
>I have a SparcStation 2 with an old GX board from a 20Mhz SS1 installed in
>it.  When I run the utility fpversion (Included with the unbundled C
>compiler) on the SS2, it replies with
>
>A SPARC-based CPU is available.  
>CPU's frequency appears to be 33.0 MHz.

I am posting the answer to my own question here.  If you do not have the
updated version of fpversion, then you get the output shown above. The
updated version of fpversion reports:

A SPARC-based CPU is available.
CPU's clock rate appears to be approximately 40.3 MHz.
The clock rate is probably 40.0 Mz.

Sun-4 floating-point controller version 2 found.
A TI TMS390C602A-based FPU is available.
FPU's frequency appears to be approximately 39.7 MHz.
The clock rate is probably 40.0 Mz.

Use "-cg89" floating-point option.

Hostid=0x55406E4C.

Thanks again to those who responded (and for the new version of fpversion!)

Bruce Allen