Where does getty get its information?

[Geoff Coleman]

In article <6411 at awdprime.UUCP> jfh at greenber.austin.ibm.com (John F Haugh II) writes:
>In article <6 at kb2ear.ampr.org> elr at kb2ear.ampr.org (Ed Ravin) writes:
>>I chmod the tty device to 666 then Kermit works fine, but after a user
>>signs on and off again, (and getty is restarted), the protection goes
>>back to -w- (write only) for outsiders.
>
>You need to run Kermit set-[UG]ID so it can take control of the port you
>are trying to access.  This is how most of the other commands which
>work with ttys operate.  Also, you need to modify Kermit so it uses the
>tty-locking routines which the system comes with.  These are used by
>getty (tsm) and UUCP - if you don't do this you will find Kermit getting
>in the way of other applications.

	There is an APAR in for this problem and I believe a fix is also
now available which will allow permissions for ports to stay at 0666. 

	For the last time SUID is not a fix!!!!!!!!!!!!!!!!

Geoff Coleman
Unexsys Systems
>-- 
>John F. Haugh II      |      I've Been Moved     |    MaBellNet: (512) 838-4340
>SneakerNet: 809/1D064 |          AGAIN !         |      VNET: LCCB386 at AUSVMQ
>BangNet: ..!cs.utexas.edu!ibmchs!auschs!snowball.austin.ibm.com!jfh (e-i-e-i-o)