32 Mega bytes MacII fx and A/UX 2.0 ?

David W. Berry dwb at archer.apple.com
Thu Jun 28 03:46:19 AEST 1990


In article <b.IN9XII at bse.com> eberard at bse.com (Edward V. Berard) writes:
>I currently have a Mac IIfx with 8 megs of ram. Shortly, I will have an Apple
>CD ROM drive. Until now, I have been under the following impressions:
>
>	1. While I could install both AUX 2.0 and upgrade my memory to 32 megs,
>	   at best, a Multifinder partition could only use up to 8 megs. So, there
>	   was apparently no benefit, on the Mac OS side, to upgrading the amount
>	   of memory. Apparently this is incorrect. Specifically, based on the
>	   above comments, it would seem that, with AUX 2.0 installed, I could
>	   in effect, have Multifinder running with more than the usual 8 megs
>	   limit. Is this correct? If it is, what are the practical upper limits
>	   for the amount of memory allocated to a Multifinder partition under
>	   AUX 2.0?
	Just to clarify.  The Macintosh OS, running in 24-bit mode (the normal
	state on the Mac today, can only use 8 meg of physical memory.  There
	are a few hacks (Virtual and the 7.0 virtual memory) which will allow
	you to access up to 14-# of slots filled, meg of virtual memory, but
	you are still limited to 8 meg of physical memory.  There is currently
	only one way to take advantage of more than 8 meg of physical memory
	and that is to run A/UX.  If you run MultiFinder under A/UX, you are
	currently allowed to create a Macintosh partition with up to 16 meg
	of virtual memory (sitting on top of however much physical memory
	you put in the machine, even more than 8 meg...)

>
>	2. There are a number of applications which normally run under the Mac OS
>	   which have problems with AUX 2.0. I currently use software from common
>	   vendors, e.g., Microsoft, Aldus, and Care (OmniPage). If I went to
>	   AUX 2.0, I would have problems with some of my software. Is this still
>	   true? Are there any "major" pieces of Mac software which cannot run
>	   under AUX 2.0?
	Much of this is from memory, but I believe that current versions of
	Microsoft products, PageMaker and OmniPage all run under A/UX.
	OmniPage can't access scanners, though, so it is of limited value.
	I know that Microsoft Word 4.0 and Excel 2.2 both run just fine
	under A/UX, as I run them on a daily basis.

	David W. Berry			A/UX Toolbox Engineer
	dwb at apple.com



More information about the Comp.unix.aux mailing list