Problems with UUCP and Telebits

[John Palmer]

In article <511455 at nstar.UUCP} larry at nstar.UUCP (Larry Snyder) writes:
}In article <3714 at thebes.Thalatta.COM>, campbell at Thalatta.COM (Bill Campbell) writes:
}> I don't remember the part number of the later uart chips, but replacing
}> your COM1 board is probably your only alternative to get as high as
}> 9600 on COM1.
}
}16550A - but the driver needs to support the FIFO buffer in the chip
}in order to do much good.
}
}When I was running SCO Xenix (2.3.2) '386 with a dumb 8 port Comtrol
... rest deleted

I'm running SCO Xenix 2.3.2 on an AT clone (386-20MHz) with a DIGIBOARD
PC/4. Sometimes, when the printer is going at the same time as a dialup
session, both the printer and the user calling in loose characters BIG 
TIME (every tenth character or so). Has anyone seen this problem, and
if so, how did you fix it?

Thanks
jpp at thundercat.com

-- 
=  CAT-TALK Conferencing Network, Prototype Computer Conferencing System  =
-  1-800-825-3069, 300/1200/2400/9600 baud, 8/N/1. New users use 'new'    - 
=  as a login id.   E-Mail Address: jpp at ThunderCat.COM                    =
-           <<<Redistribution to GEnie PROHIBITED!!!>>>>                  -