Drivers and Hardware suggestions wanted for Bell Tech Unix S5.3.2u
Stephen M. Youndt
steve at hacker.UUCP
Thu Mar 8 21:52:38 AEST 1990
First off let me thank those of you who responded to my posting,
letting me know that I was, in fact, reaching the outside world.
Second, having been properly chastized by a gentleman in Stirling, VA
for the length of my posting, I will attempt to be more concise. I apollogize
in advance if any of these questions are old, but I'm new to Unix and the
net.
I have:
Bell Tech Unix System V.3.2u w/ Software development set
on a 20 MHz AMAX 386 Motherboard w/ 4Mb, MFM controller, ST4096,
Monochrome adapter.
I would like:
The ability to drive a Orchid Prodesigner+ under X11 (VGA
drivers are not included w/ Bell Tech Unix). SCSI capability, with
about a 300Mb drive and a Tape Backup Unit also on the SCSI bus.
Bell Tech also does not support SCSI, so I need to find drivers for
that as well.
Questions:
Are VGA and SCSI/Tape/Disk drivers readily available for
Bell Tech Unix, and where can I get them? Is there a good X11 package
that will install under Bell Tech? What are good SCSI
controller/drive/TBU combinations? Is there a better, non-interlaced,
card than the Orchid PD+ for the price?
That's all for now. Mail answers/comments/questions/etc directly to
me, and I'll summarize if there's interest. Thanks in advance.
Stephen M. Youndt uunet!hacker!steve
"Hacker at Large" VMS System Programmer
More information about the Comp.unix.i386
mailing list