How do I configure a SLIP connection (VAX/750 4.3bsd)

Michael Almond mra at srchtec.uucp
Sat Jan 26 07:23:53 AEST 1991


In article <1991Jan22.204505.26234 at opusc.csd.scarolina.edu> ken at opusc.csd.scarolina.edu (Ken Sallenger) writes:
>In article <1046 at lclark.UUCP> dan at lclark.UUCP (Dan Revel) writes:
>
>=> ... setting up a SLIP connection
>=> between it and a Xylogics AnnexIIe terminal server to connect to
>=> our campus ethernet.
>
>=> I tried: 
>=> # slattach /dev/tty00 9600
>=> # ifconfig tty00 inet lclark annex31
>
>Both commands look good.  The kernel config is probably at fault.
>These commands can be put in /etc/rc.local when you get it working.

Okay, so I'm trying to run SL/IP on my Ultrix 4.1 system using DEC's
unsupported version of SL/IP (based on cslip).  I've gotten the modified
code from their support center and I've modified it to work with PSInet.

However, I can't seem to shut the connection down properly.  If I do a
kill -HUP on slattach, it just exists.  Subsequent attempts to executed
ifconfig sl0 <> <> <> give me destination address error messages.

It there a graceful way of shutting down a SL/IP connection to allow UUCP
traffic to flow?

Thanks


-- 
Michael R. Almond (Georgia Tech Alumnus)           mra at srchtec.uucp (registered)
search technology, inc.				      mra%srchtec at salestech.com
4725 peachtree corners cir., suite 200		       emory!stiatl!srchtec!mra
norcross, georgia 30092					 (404) 441-1457 (office)



More information about the Comp.unix.internals mailing list