Upgrade to 2.3.1 status

Larry Williamson larry at focsys.UUCP
Fri Jun 10 08:12:06 AEST 1988


I took a deep breath and installed 2.3.1 this afternoon. It went much
easier than I expected.

I had a look at what files were going to be installed. Mostly there
was nothing to worry about. The only files that I had to protect were
the Makefile, master and dfile.wini in /usr/linkkit/cf and the library
lib3 in /usr/linkkit and my current boot system, /system5. 

Once the install was complete, I had only to integrate my modes to
Makefile, and to add my custom devices to master and dfile.wini. Then
I made a new kernal to use these custom devices and rebooted.

Nothing to it.

I've got only one problem with the new system. Getty will not start up
on my modem. I did have getty starting on ttyM0, but now it will not
come up. My /etc/inittab entry is
	t0:23:respawn:/etc/getty ttyM0 1200R
getty is respawned over and over and over again. I am able to send data
out on this line, that is the line this news item was sent out on.

Getty is new.

I think I like the new console driver. It will take a bit of use before
I'm sure I like it, but I think it will be nice.

larry
-- 
Larry Williamson                      Focus Automation Systems
UUCP: watmath!focsys!larry    608 Weber St. N, Waterloo, Ontario N2V 1K4
                                          +1 519 746 4918



More information about the Comp.unix.microport mailing list