Problem w/ B/1

[davest%lumiere%tek.uucp at CSNET-RELAY.ARPA]

	You use B/2 to bring a 750 up single-user.

	As has been mentioned on this list before, set your console's
baud rate to 1200 to avoid needing to hit <CR> on reboot.  The problem
is one of flow control.

	When fsck is run on the root filesystem and a problem is
corrected, you should in fact NOT sync before rebooting.  This is
something that has also been discussed onthis list.

--
David C. Stewart                          uucp:    tektronix!davest
Small Systems Support Group               csnet:   davest at TEKTRONIX
Tektronix, Inc.                           phone:   (503) 627-5418