Telebit Modem and SCO Xenix 2.3.2

[Michael Johnston]

In article <158 at dmdev.UUCP> rohit at dmdev.UUCP (Rohit Mehrotra) writes:
>References: <1719 at fallst.UUCP> <1990Sep5.225421.10146 at wgc386.mv.com>
>
>In article <1990Sep5.225421.10146 at wgc386.mv.com>, bill at wgc386.mv.com (William Gibbs) writes:
>> In <1719 at fallst.UUCP> tkevans at fallst.UUCP (Tim Evans) writes:
>> 
>> >Can someone send appropriate 'gettydefs' entries for enabling
>> >incoming calls on a Telebit T2500.  Default to 9600 with
>> >cycling to other speeds.  Also, an approriate entry for 
>> >'ttys' and correct S Register settings for the modem (and
>> >for the T2500 calling it)?
>
>         Lock the speed at which the modem communicates with the port,
>	 and then let the telebit handle the speed toggling while
>	 communicating with the other modem. 

This is an OK setup where the modem , cable and, serial port are
correctly matched but will be a disaster at low speed when the
hardware handshaking fails. I don't recommend locking the interface
speed on a Telebit. Reorder the gettydefs to cycle baud rates from
19.2kbps down. It is far more reliable.



--
Michael R. Johnston, Mgr.           Internet: mjohn at citib.com
USCPG , Treasury Systems            UUCP: uunet!uupsi!bank!mjohn
Citicorp, NA                        (718) 248-5373