Request for help in adding terminals to XENIX

[davidsen at steinmetz.UUCP]

In article <267 at rabbit1.UUCP> barber at rabbit1.UUCP (Steve Barber) writes:
>I run uucp connections into PC/ATs at 4800 baud, since the darn things
>fail at higher speeds due to many dropped characters.  Does anyone know
>of a driver or driver/hardware pair that will sustain input to XENIX
>without dropping characters into the bit bucket at speeds greater than
>1200 baud?

I'm not sure what problems you're having with dropped characters. I get
my uucp feed from a VAX at 9600, and have run 9600 modems for testing.
Not only do I not get dropped characters, but I have done 9600 modem
connections while the uucp was running. I gave up on 9600 modems for
other reasons, but I haven't seen any dropped characters. I'm running
one AST ATvantage (sp?) board and one old IBM serial I snarfed from an
XT. I just wish wish Xenix supported 19.2kb...
-- 
bill davidsen			sixhub \
      ihnp4!seismo!rochester!steinmetz ->  crdos1!davidsen
				chinet /
ARPA: davidsen%crdos1.uucp at crd.ge.com (or davidsen at crd.ge.com)