Adaptec controller and Tape backup
Wain Dobson
wain at seacbc.UUCP
Wed Dec 28 06:39:38 AEST 1988
In article <1330 at bc-cis.UUCP> raanan at bc-cis.UUCP (Raanan Herrmann) writes:
>
>Background: Compaq 386 25 Mhz, Xenix 2.2.3, Adaptec ACB-2322 disk controller,
>Miniscribe 320Mb disk-drive, Wangtek tape drive connected to a Bell
>Technologies tape controller and the XTC driver.
>
>Problem: tape drive does not respond properly in Xenix and DOS modes -
>obviously there is address/interrupt/DMA conflicts (A/D/I).
What I cannot figure out is how you got the Wangtek, Bell Tech Controller, and
XTC driver to work. I have tried the combination under Bell Tech, first
release; Microport V/386 (last two versions), SCO 2.1.1 and 2.1.3 /286,
SCO 2.2.2 /386. All that I got was a long long wait while backing up. This has
been with a variety of controllers and drives.
--
Wain Dobson
...!{uunet,ubc-cs}!van-bc!tessera!seacbc!wain
More information about the Comp.unix.xenix
mailing list