Using SLIP with SCO Xenix/Unix

[J.T. Conklin]

In article <260F7FA9.4661 at tct.uucp> chip at tct.uucp (Chip Salzenberg) writes:
>SCO TCP/IP for Xenix supports SLIP.  It works; I've used it.  However,
>be warned: SCO SLIP works *only* with SCO serial drivers, so it will
>*not* work with intelligent boards that come with their own drivers.

Not true.  We use a Bell Tech HUB-6 card w/16550's and a driver developed
by Stuart Lynne for our SLIP link.  The driver was written before we had
SLIP, so I'm pretty sure nothing special had to be done to get it to work.

	--jtc
-- 
J.T. Conklin
	...!{uunet,ubc-cs}!van-bc!jtc, jtc at wimsey.bc.ca