Fujitsu M2249E (hard disk) in an IRIS 3130

[Mark Bradley]

In article <882 at amethyst.ma.arizona.edu>, chris at spock (Chris Ott) writes:
> 
>      I have the following problem: I have a disk drive that was purchased
> by another person. I would like to install it on our IRIS 3130, but I
> can't find any documentation for it. I've tried to format it and check it
> out with the "sifex" program, and it formats okay, but it comes up with
> many errors when I try to run tests on it. The disk is a Fujitsu M2249E,

The 2249 is not viable on the 3130's ESDI controller.  The only 380 MB
drive that is qualified to run on the 3130 is a semi-custom version of
the Micropolis 1558-15. 
>      It would also be nice to have the following information:
> 
>   1) How big is it? (megabytes)

It is a 380 MB drive.
> 
>   2) How many heads/cylinders/blocks per cylinder does it have?

1243 cylinders, 15 heads, 34 sectors/trk.  Gaps should be set to 0x19,
0x13 and 0x26.  It will run best at a 2:1 interleave, but not reliably
at all.
> 
>   3) What do all of the jumper selectors do? I have documentation for our
>      Hitachi disk, so I can read the jumpers off of it and set the
>      appropriate jumpers on the Fujitsu.

The jumpers are for address and bytes/sector.  Some others are factory set
and should not be tampered with.  You should be able to get specifics from
Fujitsu Americas Support organization (jumper locations often change when
drive is rev'd) at (408)432-1300.
> 
>      Any information would be _greatly_ appreciated.
> 
						markb

--
Mark Bradley				"Faster, faster, until the thrill of
IO Subsystems				 speed overcomes the fear of death."
Silicon Graphics Computer Systems
Mountain View, CA			     ---Hunter S. Thompson