Tek pahser PX

[Alan Davis]

  I am trying to use a Tektronix Phaser PX on a PI 4D/35 3.3.2 without much
luck.  I have been using both tocolps and tops to make color PostScript which
I am sending to the printer.  The quality of the print is extremely poor, the
image comes out with a very mottled appearence, like something happened
during the dithering, ie the whole image is speckled with white dots.  I assume
you must be able to make normal prints on this printer and would like to hear
from someone who has done this already.  All my other experience is with the
4693D which makes very good prints.  Thanks in advance.
_______________________________________________________________________________
            Alan Davis            | INTERNET  davis at masig1.ocean.fsu.edu
       MS B-174, Love 008A        | SPAN      fsu1::davis
  Mesoscale Air-Sea Inter. Group  | BITNET    davis%masig1.ocean.fsu.edu at fsuavm
    Florida State University      | Phone     904-644-3798
   Tallahassee, FL 32306-3041     | FAX       904-644-8579
_______________________________________________________________________________