ULTRIX 3.1

[Frank Wortner]

In article <11657 at boulder.Colorado.EDU>, bobk at fred.colorado.edu (Bob Kinne) writes:

> We are now running ultrix 3.0 on both VAX and RISC machines.  We
> have obtained WS 2.1 (ultrix 3.1) upgrade tapes through the local
> CNS, which has an arrangement with our DEC salesperson that makes
> them the sole source for DEC SW (we can't get it through DEC without
> paying full list price).  Unfortunately there is no documentation
> of any kind available.

It is available, but some tapes shipped without copies.  This was an error.
Tell CNS or the DEC salesperson that you need a copy.  They are available and
you *are* entitled to one.  The DEC part number is AA-ME85-TE.
 
> What I need to know is:
> 1. Is the 3.1 a replacement or an upgrade?  

It's an upgrade.  Keep the subsets you have now and use setld to load in
upgraded versions.  Be sure you upgrade ALL your loaded subsets, though.

> 2. What about the U01 'new processor upgrade' for 3.0 on the VS3100?
> Is it still needed?

I believe 3.1 takes care of that problem.

> 3. Assuming 3.1 is an upgrade, what is the correct ordering?
> First 3.0, then 3.1, then U01, or 3.0, U01, then 3.1?

3.0, U01, and then 3.1

> 4. Can the microVAX 3500 server be upgraded using the WS 2.1 tapes,
> or is another version needed?

There is only one upgrade tape.  It will upgrade either workstations or
servers.   Of course, you must use the proper tape for each architecture.
VAX tape for VAXen, RISC tape for RISCen.  :-)

Regards,

					Frank