Serial problems on DecStations?
Steve Watt
steve at wattres.UUCP
Wed Feb 21 04:31:32 AEST 1990
In article <6152 at umd5.umd.edu> hans at umd5.umd.edu (Hans Breitenlohner) writes:
>In article <423 at wattres.UUCP> steve at wattres.UUCP (Steve Watt) writes:
>>I have discovered why this doesn't work: If you hang an oscilloscope off of
>>the serial port on the DECStation 3100, you see a voltage swing of -5v to +5v
>Personally, I would consider anything that can not operate on +/- 5 Volts
>broken. (I assume that is under load, not open circuited).
The +-5 was unloaded. Loaded, it dropped to about 4.8v, definitely below
the threshhold. Since +-5 is exactly at the edge of the acceptable band,
I don't think that it is broken. The intent of the band is for the voltage
drop that occurs on longer wires.
>I would be surprised if your modem was powered from the interface, but
>if it is, it may be fairly easy to substitute a highere voltage on the
>appropriate line.
The modem (a VenTel Pathfinder 18K) is definitely NOT powered from the
RS232 line. It comes with a rather large transformer.
Just curious: Does anybody know of an "RS232 signal booster" of some sort?
Like where to buy one, or schematics or something?
--
Steve Watt
...!ames!claris!wattres!steve wattres!steve at claris.com also works
Is rm -rf a way to remove high-frequency noise? (No names mentioned! :)
More information about the Comp.unix.ultrix
mailing list