How to use uucp on a VAXstation 3100 via Telebit modem?

[Johan Vromans]

In article <JV.90Jul12231352 at mhres.mh.nl> jv at mh.nl (Johan Vromans) writes:

johan> I have connected a T2000 to the VS_SLU (/dev/tty02, standard
johan> cable, pins 2,3,6,7,20 straight through). I changed
johan> /usr/lib/uucp/addmodems to accept 9600 baud for a telebit, and
johan> used /etc/uucpsetup to configure this line "shared". No changes
johan> to /etc/modecap.
johan>
johan> I cannot get tip/cu to work to dial manually, but UUCP works
johan> fine.  I'm using this line for both dialin and dialout with
johan> only one problem: the jobs apparently do not get a HANGUP when
johan> the carrier drops.  Fortunately uucico times out after a
johan> while...

I seem to have mistaken about the HANGUP - it works as it should. Jobs
get killed when the carrier drops.

These are the settings I use in the T2000:

E0 F1 M1 Q0 T V1 X1     Version CA4.04 LIB:NDL
S00=001 S01=000 S02=043 S03=013 S04=010 S05=008 S06=010 S07=040 S08=002 S09=006
S10=007 S11=070 S12=050
S41=000 S45=000 S47=004 S48=000 S49=000
S50=000 S51=255 S52=000 S53=002 S54=000 S55=000 S56=017 S57=019 S58=000 S59=000
S60=000 S61=045 S62=003 S63=001 S64=000 S65=000 S66=001 S67=000 S68=255
S90=001 S91=000 S92=000 S95=000
S100=000 S101=000 S104=000
S110=255 S111=255 S112=001
S121=000
 
Johan
-- 
Johan Vromans				       jv at mh.nl via internet backbones
Multihouse Automatisering bv		       uucp: ..!{uunet,hp4nl}!mh.nl!jv
Doesburgweg 7, 2803 PL Gouda, The Netherlands  phone/fax: +31 1820 62911/62500
------------------------ "Arms are made for hugging" -------------------------