backspace delays on 3B2 PORTS cards

Stephen J. Friedl friedl at vsi.UUCP
Sat Feb 27 15:30:22 AEST 1988


Netpeople,

     We've been running a 3B2/400 for a while and have been
through a number of releases of the operating system.  One chron-
ic problem is that PORTS cards (the ones with a parallel port
and four serial ports) seem to add delays when backspaces are
written.  Try this:

        $ echo "xxxxxxxxxxxxxxxx\b\b\b\b\b\b\b\b\b\b\b\b\b\b\b\b"

and watch the cursor blow by the xxxxx and then move noticeably
slower on the backspaces -- I timed it at around 300 baud.
There are no backspace delays set via termio -- I wrote a hand-
full of little programs to open the port in absolutely *raw* mode
to no avail -- but I still get the delays.  If I set the high bit
the \b goes out quickly, and this problem does occur on the EPORTS
cards.

     I have seen this on every 3B2 I have been on and AT&T has no
answer for me.  Has anybody else seen this?  Any suggestions?
I've already rewritten some of my termcap/terminfo entries to use
alternate move-the-cursor-left strings but sometimes there are no
other ways than to use backspace.  Sigh.

     Thanks,
     Steve
-- 
Life : Stephen J. Friedl @ V-Systems, Inc/Santa Ana, CA    *Hi Mom*
CSNet: friedl%vsi.uucp at kent.edu  ARPA: friedl%vsi.uucp at uunet.uu.net
uucp : {kentvax, uunet, attmail, ihnp4!amdcad!uport}!vsi!friedl



More information about the Comp.unix.wizards mailing list