Memory in Everex??

[Jonathan Bayer]

jessea at dynasys.UUCP ( Sysadmin.) writes:

>I have an Everex Step 386/16 with two MB of memory on the motherboard.  I would
>like to upgrade to 4MB.   I don't want to get in from Everex because its
>expensive and I don't need 25ns chips.  So, here's my questions:  
>	1)  Is it better to get SIMMS and put them into the motherboard or
>	buy an memory expansion board and add memory to it?
>	2)  If its the memory expansion board route I should go, what brand

The only memory expansion board that will work correctly is one sold
by Everex, since it will use the 32 bit bus.  All other boards will use the
16 bit bus, and while they _might_ work they will be extremely slow.

Regarding whether going the board or motherboard, it doesn't really matter.
Replacing the chips on the motherboard will be cheaper.

>	4)  Last question is, what is a good memory speed to go with?  I've
>	got 25ns chips, but I'm planning on getting slower memory and selling
>	these (as I have to have the same speed and I'm not about to pay the
>	prices for 25ns chips).  Suggestions?  60ns?

You may not like it, but go with the same speed chips that the computer 
already has.  Everex put those chips in for a reason.  Don't second guess
the engineers because you will end up with a computer that will be giving you
parity errors all the time.


>Thanx in advance for the help. 


Your welcome.




JB
-- 
Jonathan Bayer		Intelligent Software Products, Inc.
(201) 245-5922		500 Oakwood Ave.
jbayer at ispi.COM		Roselle Park, NJ   07204