Irwin drivers not working in 2.3.2

[Macy Hallock]

Well, I downloaded xnx130 from sosco, which is the new Irwin driver
software, and installed it.
(Yes, I know its on hold again, but that's just for write protect
recognition only)

Now - I can't use the tape drive.  I get I/O error messages from the
driver.  I am using a known good (under MS-DOS w/EZTAPE 2.01) 125 drive,
with an Adaptec 2372A controller with the 125 as floppy position 2.

I either need this fixed, or a way to return to the original Irwin stuff
in the 2.3.1 release. (What do I delete/reinstall? Can I do it w/custom?)
I had this working, before I decided to "improve" and "upgrade".  All
my earlier backups are in this original SCO Irwin format on DC-1000 tapes.
All I have on floppy is the original installation diskette set.

I've been fighting with this on and off for a month and I'm licked.
Anyone know the answers?

Regards,

       Macy Hallock               fmsystm!macy at NCoast.ORG
       F M Systems, Inc.          hal!ncoast!fmsystm!macy
       150 Highland Dr.           uunet!hal.cwru.edu!ncoast!fmsystm!macy
       Medina, OH 44256           Voice: 216-723-3000 X251