uucico: NO DEVICE

[Hans Jespersen]

In article <2408 at spdcc.SPDCC.COM> cspencer at ursa-major.spdcc.COM (Cliff Spencer) writes:
>I'm trying to bring up uucp 3.51 on a 3b1. I have not run any
>configuration stuff from ua other than to set the date. When I 
>try to run uucico it reads the L-devices file, but then exits
>with NO DEVICE. [stuff deleted]

I'd check for a lock on the port (tty000). 
Look for /usr/spool/locks/LCK..tty000 or
perhaps  /usr/spool/locks/LCK..systemname
where "systemname" is the name of the system
that you are trying to cu to. If the lock file
is there just blow it away and try again.
If this fails try using "uucico -x9 -ssystemname"
the x9 gives you the largest amount of debugging
info. Another option is to look at /usr/spool/uucp/LOGFILE.
Hope some of this babbling helps.

---------------------------------------------------------------------
Hans Jespersen                 UUCP: uunet!attcan!hjespers 
AT&T Canada Inc.                 or     ..!attcan!nebulus!arakis!hans
Toronto, Ont.                  #include <sdt.disclaimer>