AIX Access on Zenith Z-386

[Russell A. Heise]

 wieland at ea.ecn.purdue.edu (Jeffrey J Wieland) writes:

 > I have been trying to run AIX Access version 1.1.1 on a Zenith Z-386
 > with MS-DOS 4.01.  The drivers load OK, but when after pccinit runs,
 > the system will hang if you try to use any of the resident MS-DOS
 > commands (DIR, TYPE, etc.).  I am using a 3Com 3C503 ethernet card.
 > It will also hang if I just install it for RS-232.
 >
 > Is AIX-Access not compatible with the Zenith?

 AIX Access for DOS Users is *only* compatible with DOS 3.3.  This is a
 limitation of the AADU package.  If this poses a problem, contact your
 local IBM rep and impress strongly upon him/her your needs and concerns.

Russ Heise, AIX Technical Support, IBM