Does uu/ungetty force S0=1 for dial out lines?

[Oliver Boehmer]

In <578 at twg.bc.ca> bill at twg.bc.ca (Bill Irwin) writes:

>chip at chinacat.Unicom.COM (Chip Rosenthal) writes:

>:The moral of the story is if you are going to put a modem on the
>:line - even if you aren't running uucp upon it - then make sure
>:there is a good Devices entry.

>I have come to the realization that the &hayes2400 entry in
>Dialers was running whenever the port was enabled.  By specifying
>the hayes1200 dialer, which doesn't set S0, the problem is gone.
wrong. The entry &hayes2400 is executed when the port is brought up to
default state, after the connection is finished. uucp executed the
hayes2400-line (w/o &) via uuchat prior to dialing. Afterwards, it executes
the &hayes-line.
oli
-- 
---------------------------------------------------------------------
Oliver Boehmer, Frankfurt, Germany    uucp:   oli at odbffm.incom.de
+49-69-331461 (voice) +49-60-308265 (12/2400)
If God is perfect, why did He create discontinuous functions?