ansi cursor controls

Tue Mar 22 04:32:08 AEST 1988

I am using SCO Xenix and I am trying to port some screen tools
which use ansi escape sequences from DOS to Xenix. Unfortunately,
Xenix console does not seem to support the sequence for save and
restore cursor position. Is there a workaround or undocumented
feature I could use  to do this?

-- 
Michael Lodman  (619) 485-3335
Advanced Development NCR Corporation E&M San Diego
mike.lodman at ivory.SanDiego.NCR.COM 
{sdcsvax,cbatt,dcdwest,nosc.ARPA,ihnp4}!ncr-sd!ivory!mike

When you die, if you've been very, very good, you'll go to ... Montana.